You are not logged in.
Pages: 1
Hello,
I would like to make roofs like this: http://www.clipartlord.com/wp-content/u … 4/roof.png
How do I do that?
Thanks for your replies :)
Last edited by DB1999 (2014-12-20 09:40:29)
Offline
Push the corners of cubes until they look like that as a whole? :P
Offline
You mean by pressing the H key? I feel like that generates it a bit random.
Offline
Hold Q+mousewheel to push cube corners, F to push entire faces.
Also here is the editing tutorial for Sauerbraten, Tesseract uses the same engine and editor, only the keybindings are different, so use F10 to show all keybindings if you are in editmode.
Offline
You can also make a corner selection by holding down the middle mouse button.
Offline
Thanks a lot :)
Offline
Pages: 1